UVMILK® ULTRA 40 dairy filter housing
Article:
1 pieces/pack.
In stock
Delivery
Housing material
Food grade steel AISI 304
Wall thickness
3 mm
Connection type
clamp
Seals
EPDM in accordance with FDA 117.2600
Housing internal angles
>90°
Internal surface roughness
Ra≤ 0,8 µm
External surface
Mirror polish
Branch pipe
50
Branch pipe fitting type
Welding, DIN, SMS, clamp
- Reliability and durability
UVMILK® ULTRA 40 dairy filter housing is made of certified 3 mm thick Italian stainless steel, resistant to deformation and corrosion. Silicone seals prevent milk leakage - Ease of use
Installation of UVMILK® ULTRA 40 filter housing into the milk line no special equipment required. Clamp connections allow to reinstall the housing into any part of the system - Easy flush
UIVMILK® ULTRA 40 filter housing is easy to rinse due to its ability to easily reassemble. The housing has clamp connections, obtuse angles of the pipes and mirror polish - Quality production
UVMILK® ULTRA 40 filter housing is produced on computerized CNC machines, it has no external welds and internal seams are sanded to ensure no leaks
Housing material
Food grade steel AISI 304
Wall thickness
3 mm
Connection type
clamp
Seals
EPDM in accordance with FDA 117.2600
Housing internal angles
>90°
Internal surface roughness
Ra≤ 0,8 µm
External surface
Mirror polish
Branch pipe
50
Branch pipe fitting type
Welding, DIN, SMS, clamp
- Cut the pipe (hose) where you are going to install the housing, and fasten the connection kit with clamps or weld it.
- Install the housing into the milking system by connecting the inlet and outlet connections to the caps and to the filter housing.
- Milk enters the filter housing through the bottom inlet pipe and passes under pressure through the filter cartridge. Pure milk comes out through the outlet in the side pipe.
! The seals for the clamps must fit exactly into the slots on the housing cap and on the branch pipes, then the housing will be completely sealed
! The filter is installed after the pump
- The filter is installed after the pump with pressure 1.5 - 10 atm.
- To avoid hydraulic impact, after you install the filter first open the “ВХОД” (inlet), and then, when the housing fills up with milk, gradually open the “ВЫХОД” (outlet).
- After operating flush UVMILK® filter housing with reverse water flow, no need to disassemble it.
- The seals for the clamps must fit exactly into the slots on the housing cap and on the branch pipes, then the housing will be completely sealed.
- The silicone seals in the housing should be replaced 2 times a year.
- For efficient and long-term housing operation, treat connection of the clamp with food-grade greases.
Reviews
UVMilk LLC — we make filters
for food and petrochemical industry