UVMILK® filter housing for fine purification of milk
In stock
- Resistant to corrosion, chemicals, mechanical stress and high temperatures thanks to 3 mm thick Italian stainless steel
- The cap connects to the body with a clamp which doesn’t have thread grooves where dirt and bacteria can remain even after rinsing
- Easy to rinse thanks to obtuse angles of the pipes and mirror polish
- Quick installation and disassembly of the case thanks to clamp connections that can be disassembled in a minute
- Silicone seals prevent fluid leakage and make the housing completely tight
- Suitable for any equipment thanks to standard mountings
How it works: The dirty milk is fed into the filter housing through the side inlet pipe and distributed over the outer surface of the cartridge. Then under the pump’s pressure it flows through the cartridge from the periphery to the center. Finally, through the outlet in the bottom cap you get clean liquid with no impurities.
- Install the filter in a 90 degree section of the milk pipe (hose) after the pump
- Cut the pipe (hose) where you are going to install the housing, and weld or fasten the connection kit with clamps
- Install the housing into the milking system by connecting the inlet and outlet connections to the appropriate couplings
- Milk enters the filter housing through the side inlet pipe and passes under pressure through the filter cartridge. Pure milk comes out through the outlet in the bottom cap.
! The seals for the clamps must fit exactly into the slots on the housing cap and on the branch pipes, then the housing will be completely sealed
! The filter is installed after the pump
- To avoid hydraulic impact, after you install the filter first open the «ВХОД» (inlet), and then, when the housing fills up with milk, gradually open the «ВЫХОД» (outlet).
- The seals for the clamps must fit exactly into the slots on the housing cap and on the branch pipes, then the housing will be completely sealed.
- The silicone seals in the housing should be replaced 2 times a year.
Reviews
Farm in Chuvashia region
With fine filtration it was finally possible for us to improve milk quality while maintaining the original fat content of 3.83% and an average protein of 3.18%. In the first half of 2019 98% of the milk delivered was accepted by the processing plant as the highest grade. Since after we’ve installed UVMILK® filters the share of the highest grade milk sold increased from 81% to 98.6%. We order filters in large quantities, they are always in stock, and there have never been any hitches with deliveries.
Agricultural business in Voronezh region
UVMILK® filters process the stated volume of milk. All impurities, dirt and clots of mastitis cells are clearly visible on the used filter. All indicators of milk quality correspond to the highest grade since we started filtering our milk. We’ve been using these filters for 5 years, and it’s been 5 years since the last time a dairy processing plant didn’t accept our milk.
Farm in Belgorod region
We have been working with UVMilk for a long time, the quality of the filters does not fail. Since we increased our livestock, we’ve switched from 5-ton filters to 10-ton filters. We clean cold milk, more dirt is retained on the upper layers, less by the middle of the filter. Filters do not affect the fat content in milk, the component premiums do not change. We sell our milk to two dairy processing plants, and both of them give our milk the highest grade.
UVMilk LLC — we make filters
for food and petrochemical industry