UVMILK® SL Mesh filter for preliminary purification of milk
Clear your milk from any large mechanical impurities (straw, sawdust, insects, particles of manure and feed) with special construction of the filter, combining perforated steel sheet and 250 μm mesh
In stock
- Improved milk filtering
with 2-layer filter construction that efficiently removes large mechanical impurities from your milk - Reduced waste
thanks to filter construction, free from replaceable parts and electricity operation - Improved efficiency of other filters
due to preliminary milk filtering which retain large mechanical particles that otherwise would clog the next finer levels of milk filtration - Deformation and rupture resistance
thanks to a rigid perforated filter frame that protects the mesh from rupture - Breakage protection and extending dairy equipment life time
due to preventing pressure surges that may occur in case that large mechanical particles clog units and assemblies of dairy equipment - Time and labor cost reduction
due to long filter operation before washing and easy backwashing
How it works: The dirty milk is fed through the side inlet pipe into the filter housing. Then under the pump’s pressure it flows through the cartridge from the periphery to the center. Finally, through the outlet in the bottom cap you get clean liquid with no impurities. The filter structure combines perforated stainless steel sheet and braided steel mesh which provides double filtration and more safe construction.
The filter mesh winding is made of triangle wire which is fixed on lengthwise stringers of perforated stainless steel sheet. They are fixed by micro welding at each intersection point, so thereby it gets into a united non-separable structure.
The special triangle wire totally excludes the possibility of clogging the slots of the filter. The cartridge is angled to the flow axis and totally covers flow area which filters milk from any mechanical impurities. These filters can work at high pressure conditions which provide stable work in case of a sudden hydraulic impact.
- Install the filter to the milk line at a 90 degree angle.
- Cut the pipe (hose) where you are going to install the housing, and fasten the connection kit with clamps or weld it.
- Install the housing into the milking system by connecting the inlet and outlet connections to the caps and to the filter housing.
- Milk enters the filter housing through the side inlet pipe and passes under pressure through the filter cartridge. Pure milk comes out through the outlet in the bottom cap.
! The seals for the clamps must fit exactly into the slots on the housing cap and on the branch pipes, then the housing will be completely sealed
! The filter is installed after the pump
- Use UVMILK® SL mesh filter while milking when milk is warm to prevent dissolution of impurities and large particles getting into milk line.
- After milking flush UVMILK® SL mesh filter cartridge with reverse sanitizing water flow, no need to disassemble it.
- The seals for the clamps must fit exactly into the slots on the housing cap and on the branch pipes, then the housing will be completely sealed.
- The silicone seals in the housing should be replaced 2 times a year.
- For the most efficient filtration complete your milk line with 4 filtering levels with UVMILK® Sock filter, UVMILK® Standard and UVMILK® ULTRA Practic.
Reviews
UVMilk LLC — we make filters
for food and petrochemical industry