UVMILK® Sock 460*60 filter housing for rough purification of milk
In stock
- Resistant to corrosion, chemicals, mechanical stress and high temperatures
thanks to 3 mm thick Italian stainless steel. - The cap connects to the body with a clamp
which doesn’t have thread grooves where dirt and bacteria can remain even after rinsing - Easy to rinse
thanks to obtuse angles of the pipes and mirror polish. - Quick installation and disassembly of the case
thanks to clamp connections that can be disassembled in a minute. - Silicone seals
prevent fluid leakage and make the housing completely tight. - Suitable for any equipment
thanks to standard mountings.
How it works: The dirty milk is fed into the filter housing through the top inlet pipe in the housing cap and distributed over the outer surface of the cartridge. Then under the pump’s pressure it flows through the cartridge from the periphery to the center. Finally, through the outlet in the bottom cap you get clean liquid with no impurities.
- Install the filter in the hose after the receiver jar and the pump
- Cut the hose where you are going to install the housing, and fasten the connection kit with clamps
- Install the housing into the milking system by connecting the inlet and outlet connections to the caps and to the filter housing
- Milk enters the filter housing through the top inlet pipe in the housing cap and passes under pressure through the filter cartridge. Pure milk comes out through the outlet in the bottom cap.
- To use this filter with the filter housing you already have, remove the spiral first, then use the adapter to hold the filter in place and fasten the cap.
! The seals for the clamps must fit exactly into the slots on the housing cap and on the branch pipes, then the housing will be completely sealed
! The filter is installed after the pump
- To avoid hydraulic impact, after you install the filter first open the “ВХОД” (inlet), and then, when the housing fills up with milk, gradually open the “ВЫХОД” (outlet).
- The seals for the clamps must fit exactly into the slots on the housing cap and on the branch pipes, then the housing will be completely sealed.
- The silicone seals in the housing should be replaced 2 times a year.
Reviews
UVMilk LLC — we make filters
for food and petrochemical industry