UVMILK® SL Two-level pumping and filtering station

1. Housing (1) and back lid (3) with the seal (6) connect with the clamp (5), screw it (7);

2. Filtering cartridge (4) should be adjusted on one side to the pilot nipple (2), on another side a seal should be installed (6) and the lid (2) fixed to the housing by a clamp (5) and a screw (7);

! The seals for the clamps must fit exactly into the slots on the housing cap and on the branch pipes, then the housing will be completely sealed (2, 3, 6)

! It's important not to confuse «ВХОД» (input) and «ВЫХОД» (output) of the milk flow.

3. Pump 

• Use UVMILK® SL Two-level pumping and filtering station while milking when milk is warm to prevent dissolution of impurities.
• The pump motor is connected via a motor-protective circuit breaker.
• The pump is started when the discharge valve is closed and the casing of the pump flow path and the suction pipe are completely filled with liquid.
• Limit the pumped liquid supply with a valve for discharge with obligatory control of the current in the windings. The current should not turn on, the unit is on the nameplate of the electric motor.
• To avoid hydraulic impact, after you install the filter first open the «ВХОД» (input), and then, when the housing fills up with milk, gradually open the «ВЫХОД» (output).
• After milking flush UVMILK® slotted filter cartridge with reverse sanitizing water flow, no need to disassemble it.
• After the declared amount of milk passes through the filter or after you finish milking, remove the replaceable cartridge and dispose of it together with other solid waste.
• One filtering cartridge should be used for one milking only.
• Wash the milking system each time and use a new filtering cartridge for each milking to prevent bacterial cell grow and milk go sour.
• The seals for the clamps must fit exactly into the slots on the housing cap and on the branch pipes, then the housing will be completely sealed.
• The silicone seals in the housing should be replaced 2 times a year.